Dynamat 10425 18" x 32" x 0.067" Thick Self-Adhesive Sound Deadener with Xtreme Wedge Pack
Stop fighting engine rumble, speaker rattle, road noise and buzzing vehicle parts! Apply Dynamat Xtreme to your vehicle's resonant surfaces and enjoy improved clarity, loudness and bass response from your car stereo. High-performance Dynamat Xtreme is lighter than Dynamat Original, four times more effective, requires no heat to apply and is recommended for vehicle tops, sides and contoured areas. Dynamat Xtreme is coated with aluminum for high temperature areas such as firewalls and floors. Kit contains one 18" x 32" piece of Dynamat Xtreme for general use on rear decks, doors, floors and the trunk floors. Unlike Dynamat Original, Dynamat Xtreme is also recommended for trunk lids, roofs, quarter panels and under-hood installations.
Pyramid PS15KX 10 Amp 13.8-Volt Power Supply with Cigarette Lighter Adapter
Manufacturer: Sound Around
The PS15KX is perfect for home, shop, or hobbyist. It provides 10amp constant and 12 amp surge. The convenient cigarette lighter plug lets you power ANYTHING that will run off a 12V car cigarette lighter. The Short Circuit & Thermal Overload Protection ensure strong safe power.
The Bitwriter programs directed electronics ESP2 systems quickly and accurately. It can program most security and concenience systems including most remote start and keyless entry systems. It is a self-diagnostic tool for trouble shooting Directed ESP amplifiers.
This slot vented enclosure was made to do one thing, HIT LOW BASS!! If low and loud is what you are trying to achieve, and are on a tight budget, then this enclosure will cure all your needs. We construct all of our enclosures from 3/4" material to ensure the best construction for your dollar. Don't be fooled by those 5/8" knock offs, built only god knows where. With this R/T enclosure you are getting a hand crafted, built in the U.S.A enclosure that will last beyond a week after putting it in your trunk.
Manufacturer: POWER ACOUSTIK
Brand: Power Acoustik
Power Acoustik 2.0 Farad Digital Power Capacitor. This capacitor in particular when installed, the first thing required is to charge before connecting to power source. Once charged it needs to be connected directly to the power +/- or in other words parallel to the battery so it will be charged at all times and of course doing the job it is supposed to do. The display on this capacitor once connected, should be adjusted with a voltmeter to the voltage read at the point of connection with the voltage adjustment on top of the capacitor. For example if the voltmeter reads 12 Volts, the voltage should be adjusted to show in the display of the capacitor exactly the same as in the voltmeter. After everything is setup correctly, the display will go off after a while and will turn on once current is drawn from the battery or a radio/ amplifier is turned on and use some voltage/amperage from the battery
Puck transducers mount to the inside of most fiberglass hulls and transmit the sonar signal through the hull. The hull must be of single layer fiberglass construction. (Cored fiberglass, metal or wood are not acceptable) and be free of trapped air and voids. The transducer is glued in with slow cure epoxy.15ft cable and epoxy included. This model will work Matrix 10, 15, 17, 20, 25, 27, 55, 65, 67, 77c, 87c, 97; Piranha 1**, 2**, 3*, 4*, 5*; PiranhaMAX 210*, 215*, 220*, 230pt*; Fishfinder 515, 525, 535, 565, 580, 585c, 595c; 931c, 937c; 323, 343c, 363, 383c; 717, 727, 747c, 757c, 767, 777c, 787c; 917c The Humminbird XP 9 20 Puck Transducer is designed to mount to the inside of most fiberglass hulls with a deadrise less than 15 degrees, and transmit the sonar signal through the hull itself. Your boat's hull must be of single-layer, fiberglass construction and be free of trapped air or voids in order for a puck transducer to operate correctly, so cored fiberglass, metal and wood will not work. This unit is meant to be glued to your inner hull with a slow-cure epoxy, which is included, and connects to your compatible Humminbird sonar or fish finder system via the included 15-foot cable. The Humminbird XP 9 20 is a single/dual puck transducer and is designed to be used with Humminbird's; Piranha 1, Piranha 2, Piranha 3, Piranha 4, Piranha 5, PiranhaMax 10, PiranhaMax 15, PiranhaMax 20, Matrix 15, Matrix 17, Matrix 25, Matrix 27, Matrix 55, Matrix 65, Matrix 67, Matrix 97, FF515, FF535, and FF565. This item is backed by Humminbird's one-year limited warranty.